Connections & installation
Mount the display in its cut-out and connect the power supply (12–24 VDC) and the signal line. It uses the Movilift serial CANbus; set the node with the on-board addressing.
- Keep the signal wiring away from power cables
- Check the diagnostic LED lights at power-up
- Verify polarity before energising
Programming & parameters
The display has an on-board programming menu driven by the ADV and OK buttons: ADV enters the menu and scrolls parameters, OK opens a parameter and confirms its value. The value is stored when SA appears; after 10 seconds of inactivity the display returns to the main screen.
- P1 – edit floor symbol
- P2 – auto power-off (minutes)
- P3 – buzzer volume
- P4 – insert floor
- P5 – delete floor
- P6 – demo mode
- P7 – enable call / gong
- P8 – planned floor
- P9 – floor offset
- PA – brightness
- PB – diagnostic data
Diagnostics & firmware update
The PB parameter shows diagnostic data and the diagnostic LED reports the line status. Firmware update is not applicable on this model.
- A factory reset restores the default parameters
- Check the serial line if the floor is not shown