Control boards

The core of the controller: 32-bit EN 81-20/50 certified operation, from the compact board up to 32 stops on serial CAN — plus the multiplexer for groups.

★

BR200

32-bit lift control mainboard for machine-room and MRL elevators — EN 81-20/50 compliant, with integrated battery charger, UCM monitoring and RS232/USB programming.

★

BR400

Top-of-range 32-bit lift control mainboard — up to 32 stops over serial CAN, EN 81-20/50 certified, with shaft-reading options, USB firmware update and Movicontrol remote monitoring.

BR100

32-bit lift control mainboard — up to 32 stops over serial CAN, EN 81-20/50 certified, with shaft-reading options, USB firmware update and MoviControl remote monitoring.

BR50L

Compact 32-bit lift control mainboard — up to 32 stops over serial CAN, EN 81-20/50 certified, 15 settable I/O, USB firmware update and MoviControl remote monitoring.

BRMUX

Multiplex control board that links up to five BR motherboards for duplex, triplex, quadruplex and multiplex groups.

Serial landing and car boards carrying calls, I/O and information over the Movilift CANbus.

CHM

Serial call-expansion board for the controller, adding cabin calls or landing inputs/outputs on the Movilift CANbus.

CHM2S

Compact serial landing interface board for landing calls and info, available as CHM2S and CHM2S-Multi.

COP

Serial car operating panel board handling cabin calls and controller information, expandable from 12 to 23 floors.

Link-Card LCD

Link-Card LCD

Collect up to 12 car calls; the LCD variant doubles as a cabin display.

Door operator control and car-top management: sensors, photocells, lighting and the emergency dialler.

Doorina

Electronic door-operator board that drives a DC brush motor with two speed profiles — encoder, limits or timing control, on-board setup and Movilift serial CAN.

GATEBOX S

Serial car-top control board that drives door operators, sensors, lighting, photocells and the auto-dialer over CANbus.

CANbus distribution, parallel-to-serial conversion, shaft position reading and programmable I/O — the parts that tie the rest together.

COD16

Display decoder board converting binary or CANbus signals to 1-wire-per-floor, 7-segment, binary or Gray display coding.

INTERFACE CAN

CANbus line distribution board that branches the Movilift serial line to landing devices.

Limax

Absolute shaft positioning system reading a magnetic tape with an ELGO sensor to manage speeds and deceleration.

NZEN

NZEN

Program NZEN and use its 6 inputs and 4 outputs to suit your needs.

REVERSE

Interface board converting parallel coding to serial CANbus for landing and cabin display indicators.